[Elecraft] Elecraft CP1 Dual Directional Coupler

[Andrew J Cunningham]

Guy's...

Hello again to one-an-all, after a very long absense from the list, and
things in general due to many matters,..
I'm glad to say for the meantime..I am back..!

I've just started construction on the "CP1 Dual Directional Coupler" as a
piece of test equipment here in the
newly re-vamped shack... And was wondering, IF there is anyone out there who
can provide me with a good quality full size (100%) scan of the CP1 board,
componant side up, AND solder side...???

I ask..because I am hopeing to enclose the pcb in a very small tin (I know
it doesnt need it, but for saftey reasons (I'm confined to a wheelchair) and
tend to drop and run over things I think it best to enclose the 
board when finished), and want to measure up the componants for placement
thru any holes that I may drill in
my enclose (altoid tin)..

I would be very greatful to y'all if some has as yet to start this pcb and
could help me with a source of
the scans..

It's GREAT! to be back...

Answers On A Postcard To The Address Below..

TIA...TFBW..

72s
Andy
GM0NWI                         andy.gm0nwi1 at btinternet.com