[Elecraft] K2 U1 part number

[Jack Brindle]

Actually the SA612 is a better part with better specs. Philips  
replaced the SA602 with it.

On Apr 21, 2006, at 3:24 PM, Nigel A. Gunn G8IFF/KC8NHF wrote:

> Same device, different number. Goo ahead and melt solder.
>
>
> Bill Reid wrote:
>> The K2 manual lists SA602 for U1 on the control board and the part  
>> number in my kit is SA612.  Is this IC OK to install?
>> _______________________________________________
>>
>
> -- 
> <><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><> 
> <><>
> Nigel A. Gunn. 59 Beadlemead, Milton Keynes, MK6 4HF, England. Tel  
> +44 (0)1908 604004       mobile +44 (0)7765 471661
> e-mail nigel at ngunn.net             www  http://www.ngunn.net  
> Amateur radio stations  G8IFF, KC8NHF
> Member of  ARRL, GQRP Club, QRPARCI, SOC #548,  Flying Pig #385,
>           Dayton ARA #2128, AMSAT-NA  LM-1691,  MKARS,  RAYNET
> <><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><> 
> <><>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com


-Jack Brindle, W6FB
=======================================================================