[Elecraft] KX1 RX deaf after KB3080 installation

[Don Wilhelm]

Bruce,

Check the end of L6 closest to the wire you added at trimmer cap CC - L6
should not connect to the trimmer pad, but it is close, so a slight solder
splash will cause a short there.

73,
Don W3FPR

> -----Original Message-----
>
> L6 is good, it measures 1 ohm. But I'm seeing only 1 to 4 ohms
> from min to max
> RF gain. That tallies with what I'm hearing- the RF gain has
> almost no effect
> on received sigs. So I'll look for whatever is pulling R1 down.
>
> Thanks again- it always helps to have a second set of "eyes".
>
> 73
> Bruce
> N7CEE
>