[Elecraft] KX1 RX deaf after KB3080 installation

[Ron D'Eau Claire]

L6 is good, it measures 1 ohm. But I'm seeing only 1 to 4 ohms from min to
max 
RF gain. That tallies with what I'm hearing- the RF gain has almost no
effect 
on received sigs. So I'll look for whatever is pulling R1 down.

Thanks again- it always helps to have a second set of "eyes".

73
Bruce
N7CEE

------------------

If you can lift one end of L6, you can then tell which side of it the short
is on. Since part of the mod was to install T2, I'd suspect it's somewhere
there. Maybe a short between the turns of the two windings since both the
primary and secondary of T2 have one end at DC ground. 

Ron AC7AC