[Elecraft] KX1 RX deaf after KB3080 installation

[Bruce Grubbs]

On Thursday 20 April 2006 06:05 pm, you wrote:
> Do you have the jumper installed in the jack next to the BNC?
> 

Yes, the jumper is in place. That's not where I looe the RX signal. It's at 
L6.

Also, the TX puts out normal power into a dummy load, so it looks like the low 
pass filter part pf the KXB3080 is OK.

> The markings on the BACK of the board are wrong. The ones shown in
> the manual on page 9 are okay.
> 

That's strange, becaue I had the KXB30 option, and its manual doesn't mention 
that the markings on the back of the KX1 board are wrong. A goes to A and B 
to B, when installing the KXB30.

Thanks, Randy. Back to troubleshooting...

73,
Bruce
N7CEE