[Elecraft] Re: Transverter inquiry

[Dennis Ponsness]

I am in the same situation and I just want to make sure that I fully 
understanding what the solution is:

I have a K2 with the K60XV option installed and will use a XV50 for 6m 
operation.  I need to have no more than 10w being produced by the XV50 so I 
don't fry my 6m brick.  I would construct the XV50 and configure it to be 
driven by a K2 with the K60XV module as per the instructions (1mW drive).  
Assuming that the XV50 is set to be TRN1, I would set the OUT parameter for 
TRN1 to .50 (.5 mW) - which would therefore make the max output of the XV50 
10w.  This would be independent on any setting of the Power control on the 
K2.  I this the correct procedure for limiting to output of the XV50 to 10w 
based on my equipment configuration?


73

Dennis - WB0WAO

EN84ij Iosco County, Michigan
K2 #3555

_________________________________________________________________
Express yourself instantly with MSN Messenger! Download today - it's FREE! 
http://messenger.msn.click-url.com/go/onm00200471ave/direct/01/