[Elecraft] Mic Problem?

[Ken Bessler]

 Don, Scott - et all - 

Thanks for the help - after doing a full reset & re-
alignment then disassembling the radio to check
for GND @ mic socket pins 7&8 (ok), I re-assembled
K2 #4913 and focused on the mic again.

I had ASSumed the mic was OK because it worked
FB in my Alinco 2m/440 mobile. Well......

After checking the mic again, I found the ground
braid was bad. I cut 2" off the plug end of the cord
and re-wired the plug. Works!

I looked for a fault in the old cord end and found the
braid was tattered & broken right where the clamp was.

Thanks again for the help!
 
      73 de Ken KGØWX - Flying Pigs #-1055
Elecraft K2 #4913 - Kadiddlehoppers #11,808