[Elecraft] Neurotic about Toroids

[Bruce Grubbs]

Lee,
After you've installed a toroid, check the resistance across the toroid leads 
(all pairs if it's a transformer) at the solder pads. If it's zero, you can 
be assured you stripped the leads properly and got a good solder joint on the 
board. Since I started doing that, I've never had a bad toroid installation.

Take your time and enjoy building your K2. Elecraft and this excellent list 
are always there to back you up, so you CAN'T fail.

72,
Bruce
N7CEE
K2 #244