[Elecraft] Just Checked MDS values on my K2

[S55M]

You must compare radios with same bandwidth if You want to do the
comparision chart.
So first measure the -3dB bandpass of filters on 1KMP and K2 and then
compare measurments in dBc/Hz.
K2 is not bad at all on RX.
My measurments:
http://www.s55m.com/teh/K2930MP.jpg

The TX chain has "some" problems, with elevated power or transverters with
high power amps attached.
Still have no time to finish hard mods of TX mixing ( i wish Elecraft would
have used same solution on Tx as on RX :)


Best DX!

S55M-Adi


----- Original Message -----
From: "Paul Webb" <m0bmn at yahoo.co.uk>
To: <elecraft at mailman.qth.net>
Sent: Thursday, October 13, 2005 4:29 PM
Subject: [Elecraft] Just Checked MDS values on my K2


Hi All



Just built the XG1 test oscillator and tested out the K2

I also have a number of other radios here that I can compare it against,
only tested a few so far but here are my results



K2  Filter set to 0.7 (which is same as 500Hz filter ,so the manual says)
AGC off, MDS value in CW Mode  :   -139dBm    Not Bad!

FT1000MP MK V with 500Hz filter  active, AGC off,  CW mode :    -137dBm
Still not bad

FT897D with 500Hz filter active ,AGC off, CW mode  :    134dBM  anything
over -130dBM isn’t bad.



So there you go ,still got to test a ft817ND and the icom 703Plus out but
that will another day, well done Elecraft !



All the best



Paul

M0BMN




--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.14/131 - Release Date: 12/10/2005

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com