[Elecraft] Sidetone lost on #4913 after installing DSP

[Jess Gypin]

Hve you checked to make sure that the side tone chip selection is correct? I
had this happen one time when I was troubleshooting a KPA100 problem. I
checked the mene selection for the source of the side tone chip and it was
set to the wrong one.

Jess AE0CW

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Ken Bessler
Sent: Sunday, October 09, 2005 3:30 AM
To: Elecraft Main Group
Subject: [Elecraft] Sidetone lost on #4913 after installing DSP


I built and installed the KDSP2 module yesterday on K2 #4913.   Before
installing, I ran a check on the radio and everything checked out. I did not
check the sidetone generator.   Now I have the DSP installed and it seems to
be working.   Problem is my sidetone is gone! I pulled the DSP and put
jumpers in to bypass the headers - no help. I had W0WKS listen on 10m while
I sent a CW message - I'm sending. I hooked up a 1/8" stereo plug to the CW
jack and sent CW - the audio cuts out and the rf meter indicates a signal is
being transmitted - just no sidetone.   Help?   73 de Ken KGØWX - Flying
Pigs #-1055 Elecraft K2 #4913 - Kadiddlehoppers #11,807
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com