[Elecraft] K2 Audio/Sensitivity Issue

[Bob Wehking]

I also took all the modules out of my K2 including the KPA100 & installed my 
Rework Eliminators to see if one of the modules was causing the issue, but I 
still have low audio & sensitivity. I did check the TX & the power across 
all bands is OK. I also put a headset on the radio without any change.

----- Original Message ----- 
From: "Bob Wehking" <rwehking at cinci.rr.com>
To: <Elecraft at mailman.qth.net>
Sent: Sunday, October 09, 2005 11:03 AM
Subject: [Elecraft] K2 Audio/Sensitivity Issue


About two months ago, I built a K2 - SN 4998 , KDSP, KSB2, KPA100 & 
everything worked.

Yesterday I built the KNB2 & K160RX boards & after installing them, my audio 
is very low except for strong SSB signals & the sensitivity across all band 
appears to have decreased. When using the XG2 signal Generator, neither the 
50uv or 1uv cause the "S" meter to indicate anything.

Anyone have any suggestions?


Bob
WB8DDI
K2# 4998

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com


-- 
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.13/126 - Release Date: 10/9/2005