[Elecraft] RE: [Elecraft} K60XV Low Voltage in VCO Alignment

[rabbott at voicenet.com]

I experienced the same low voltage problem when I installed the K60XV.  I measured just 
over .8 volts on the low end and about 1.2 volts on the high end.  I checked both C71 
and C73 and found them to be the correct value.  As the manual seems to suggest, I 
increased the voltage on the low end to just over 1 volt.  This increased the voltage at 
4000 KHz to just over 6.2 volts.  Although slightly higher than the K2 manual originally 
indicated, this compromise placed all the voltages within the acceptable range of 1 - 
7.5 volts. It appears this adjustment is necessary on at least some K60XV installations.

Ralph L. "Larry" Abbott  WA3ELQ