[Elecraft] RE:split indicator for K2

[Mark Saunders]

They must be for some kind of analog connection, what I'm not sure.  Looking at the schematic it looks like some type of input connector.  Maybe this is where you connect the wireless controller so you can hook it to a computer network for remote operation.  Ya think?  Oh, wait, 8-pins, thats gotta be the built-in rotator controller.

Mark Saunders, KJ7BS
Glendale, AZ
<><><><><><><><><><>
FISTS # 2972
Elecraft K2 S/N 539
<><><><><><><><><><>
If it aint fun,
you aint doing it right.
AZ ScQRPions
============================================================
From: "Rick Dettinger" <k7mw at cmc.net>
Date: 2005/10/04 Tue PM 02:20:32 EDT
To: <elecraft at mailman.qth.net>
Subject: [Elecraft] RE:split indicator for K2

Maybe I've finally found a use for the round hole with 8 pins located just to the left of the headphone jack. This would be a splendid home for a nice bright red LED split indicator.  Maybe I could use 2 of the pins to power the light. This is probably what the designer had in mind.  I wonder what the other 6 pins are for?        73 - Rick - K7MW    
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
============================================================