[Elecraft] K2 Muting

[S55M]

And if u have a switch, wich shorts unused port to ground it should be even
better :)))



> Switch the RX of unused radio to dummy load when transmitting with the
other
> one.
> If you want to do it "perfect" , you can use low power coax relays (cx120
or
> something smaller it depends on PWR u use) or better , transfer relays.
> If u use high isolation switch between the two radios and one antenna it
> should be enough :)
> 100W is +50dBm and if u have a switch (manual or coaxial) with at least
60dB
> of isolation it should not harm the other radio (-10dbm on ant port or
> 0,1mW).
> If u r using 5W QRP even better :)
>
>
> 73's
> Adi
> S55M
> 9A8WW
>
>
> ----- Original Message -----
> From: "R March" <n7ua at ix.netcom.com>
> To: <elecraft at mailman.qth.net>
> Sent: Tuesday, November 15, 2005 12:08 AM
> Subject: [Elecraft] K2 Muting
>
>
> > I want to switch between a K2 and another XCVR.  When I am transmitting
on
> > the other XCVR, the K2 should be muted.  Can someone enlighten me as to
> how
> > best to mute the K2 (other than keying the transmit line)?  Thanks,  Bob
> > N7UA
> >
> > _______________________________________________
> > Elecraft mailing list
> > Post to: Elecraft at mailman.qth.net
> > You must be a subscriber to post to the list.
> > Subscriber Info (Addr. Change, sub, unsub etc.):
> >  http://mailman.qth.net/mailman/listinfo/elecraft
> >
> > Help: http://mailman.qth.net/subscribers.htm
> > Elecraft web page: http://www.elecraft.com
> >
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>