[Elecraft] MH2 Microphone Discontinued

[Don Brown]

Hi

The TenTec handheld microphone works great with the K2. It comes with a 4 
pin connector that you will need to change to the 8 pin connector for the 
K2. This mike works fine with the 5.6K bias resistor from the 5 volt supply 
to the AF pin, just like the MH2.

I have also used the TenTec desk mike on the K2, however it really needs 8-9 
volts rather than the 5 volts provided by the K2. You can use the internal 9 
volt battery or jumper over to the 8 volt supply in the K2.

Don Brown

KD5NDB


----- Original Message ----- 
From: "Paul Saville" <ps250505 at xtra.co.nz>
To: <Elecraft at mailman.qth.net>
Sent: Wednesday, May 25, 2005 9:42 PM
Subject: [Elecraft] MH2 Microphone Discontinued


> The MH2 is now listed as discontinued. Will there be an Elecraft-branded 
> replacement for those who don't fancy "pop star" type microphones?
>
> 73 Paul ZL3IN
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>