[Elecraft] Installing C56 on Pins 2 and 3 of K1

[Ron D'Eau Claire]

Matt - K7OE - asked:

I need a little assistance from other KX1 builders out there.

The manual states to solder the capacitor C56 between pins 2 and 3 of the
relay K1 (page 34, right side, second step).

How do I determine which pins are 2 and 3?  I DON'T want to get this wrong
now...
------------------------------------------

Figure 13 just below that step in the manual shows C56 in place on the
center two pins (2 and 3) on the side closest to the trimmers (or where the
trimmers will go).

My apologies for the illustration showing parts that haven't been installed
yet. C56 was added AFTER I did the build and took the pictures.

Ron AC7AC