[Elecraft] weird power stuff
Lloyd Lachow
llachow at yahoo.com
Mon May 2 10:58:31 EDT 2005
While operating my K2, using the ATU with a balun
for my 300 ohm twinlead-fed loop, sometimes I've
suddenly noticed that my power out, while
transmitting, is showing only two bars, instead of the
five or six I should be seeing. If I hit tune, I
sometimes get "nothing" - no bars, and the display
says lo power. After trying a couple of things -
switching bands, or holding TUNE and DISPLAY together,
I'll get it to tune up and act normally again.
Sometimes after getting it going again, it shows all
ten bars lit up at first, then reverts to the five or
six. I did just change R98 on the RF board from 270 to
1K, which mostly resolved my too-high power out
problem.
Any ideas...? Thanks...
LL/K3ESE 11+379+4442=KX1K1K2#4832
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
More information about the Elecraft
mailing list