[Elecraft] RS-232 interface question

[David]

I have the setup that way and yes you will need the kio2 to make it all easy
to hook up it can be done with out it but you have to make a special cable
so it was easier to put the kio2 in and have it for when you go qrp and have
it for when you go qro.

----- Original Message ----- 
From: <tedwb3avd at netzero.com>
To: <elecraft at mailman.qth.net>
Sent: Tuesday, March 29, 2005 7:27 AM
Subject: [Elecraft] RS-232 interface question


>
> Hi folks.
> I'm planning on building the 100W kit for my K2, and the 100W ATU, both
together in a remote enclosure. Do I, or do I not, need the KIO2 RS-232
Interface kit, given that both the amp and the ATU are remote? Offline
replies OK, as this is probably an old question!!
> Ted WB3AVD
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>