[Elecraft] k2 control board r18, r19

[John R. Lonigro]

Jon:
If you are sure you intend to buy the audio filter, you can buy the kit 
now and install the proper connectors right away.  You can then use a 
couple of scrap resistor leads as jumpers to make the required 
connections - the same as if you had the audio filter installed and 
wanted to remove it for some reason.  The filter instructions tell you 
how.  Or perhaps you could buy and install just the headers now.  You 
can get the part number from the audio filter instructions on line.  
That would allow you to choose between the filter and the DSP unit later 
on and you'd only be out the cost of the header.  BTW, I'm not a great 
fan of desoldering, but I was able to remove the jumpers on my K2 with 
no problem.

73's and good luck,

John AA0VE

jon howe wrote:

>
> Any thoughts on a "solderless" solution to R18 and R19?
> 73,
> ve8jj
>