[Elecraft] 14361!

[S55M]

Jap Geoff!

I played a bit with my K2 to see if screening of some parts could be done.
The signal path on the bottom of main (RF) PCB is on short paths so putting
the coax lines would not do the job i think (maybe only one trace to TUF
mixer wich is abt 6cm lomg).
The area under control board vher OSC seats and DSP is not easily accessible
so i must spend some more time to see if anything can be done.
I am just having fun HI HI.


73's
Adi
----- Original Message ----- 
From: "Geoffrey Mackenzie-Kennedy" <gmk at gm4esd.fsworld.co.uk>
To: "S55M" <s55m at siol.com>
Cc: "Elecraft Discussion List" <elecraft at mailman.qth.net>
Sent: Tuesday, March 22, 2005 12:21 PM
Subject: Re: [Elecraft] 14361!


> Hello Adi,
>
> 14MHz is also the IF for my VHF transverters, but I use another receiver
and
> Tx exciter with them.
>
> When I can I want to shield parts of the K2, but I do not hope for
miracles
> because of the PCB *wires* that would go in and out of shielded areas. To
do
> a proper 100% job would be difficult, so I say to myself STOP, ENOUGH !!
>
> 73, Geoff   GM4ESD.
>
> ******************************************************
>
> Adi S55M wrote:
>
> While surfing arround on Elecraft list archives i read abt 14361 birdie.
> The common statment is "Thanks God is out of band"
> Not if You are using 144/14MHz transverter :(
>
> Adi
>
>