[Elecraft] Problem with routers and K2?

[W3FPR - Don Wilhelm]

Tony,

Have you thought about the power supply?  Is the same power supply being
used for the K2 and the TS950SDX?  Could it be that it is not RF causing
your problem at all, but trash induced on the power line?

73,
Don W3FPR

> -----Original Message-----
>
> My K2/100 sits on top of my TS950SDX. If I go above about 30-50W
> with the K2
> on 80 and 160M I have to reset my router. Was using a Belkin router. Now
> using a Netgear wireless router. Both cutout. This doesn't happen all the
> time - maybe 50% of the time. Been wrapping ferrite on everything, but no
> difference so far. Swapped the coax cables between the 2 rigs. Router is
> about 4' from the K2. I can run 100W with 950 without any problems. My amp
> is in the basement about 8' away. No problem when using it with
> the 950 and
> no problem with the K2 as long as I keep the power of the K2 below about
> 30-50W. Might have to move the K2 farther away and see if problem
> persists,
> although it will be a pain to do that. Not sure yet if problem is
> definitely
> the K2.
> N2TK, Tony