[Elecraft] Still blank display

[R. Kevin Stover]

G3VVT at aol.com wrote:
>  
> In a message dated 18/03/05 17:35:05 GMT Standard Time, n5vwn at sbcglobal.net  
> writes:
> 
> Thanks  for all the help on my blank display problem.  I've followed 
> everybody's  suggestions.  I even resoldered every point.
> 
> 
> Roland,
>  
> Check that you have soldered pin 1 on U1, the display driver on the  front 
> panel board. A common mistake is missing this soldered joint. I made  the same 
> mistake and it can be seen without removing the display. Fixed mine  without 
> removing the display, though does need a steady hand.
>  
> Bob, G3VVT
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 

I should have added if it wasn't clear that you need to remove U1 before 
trying the heated socket procedure.

-- 
R. Kevin Stover	ACØH

K2/100 #4684

Reclaim Your Inbox!
http://www.mozilla.org/products/thunderbird