[Elecraft] K2 assy: oops: threw out xtal filter bag with alignment # on it

[vze3v8dt at verizon.net]

I'm not sure how critical that exact value is.  I'm still doing assembly 
and not at that step yet.  My bag of 7 xtals has "3.7" written on it.  
All of the xtals have 4.9136 marked on them.  I assume they were all 
measured & matched at 4.9137 MHz instead of the marked value, so they 
are 100 Hz high. 

I don't see a similar number on the BFO xtals bag of  2 xtals which are 
listed as 4.915 and marked on the xtals as 4.91.  Not sure if this helps 
you.  I'll try to remember not to throw the bag away right off but keep 
it handy.  Thanks for the heads up!

Mark, NK8Q
K2 S/N 4786 (being built)

Andrew Moore wrote:

>I'm assembling the RF board on my K2, and I just reached the step that
>says:
>
>	"The bag of 7 filter crystals should have a number
>	written on it.  Record the number here: _________ .
>	This identifies the tested frequency of the
>	crystals, and can be used in aligning filters.
>
>Well, last night when I was sorting components and putting them in
>trays, I tossed the bags.
>
>Tomorrow morning is trash day, and the trash is at the curb.  Should I
>go start digging, or is it really necessary for me to have this number?
>
>--Andrew, NV1B
>
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com
>
>  
>