[Elecraft] RE: K2 assembly: tilt bail so tight it warps cover

[Craig Miller]

I don't know if this is normal but I have it too (SN 4790).  I did
notice, however, that when I attached the bottom cover to the rest of
the K2 for the initial front panel testing it seemed to straighten out
the warping.  But this does put some stress on the RF board.  I don't
know if this will have any long term effect.

Anyone at Elecraft notice this?  An out of spec batch of tilt bails?

Craig Miller, K3OOL
K2 4790