[Elecraft] 4044# dead

[Ian J Maude]

On Fri, 2005-03-11 at 11:54 +0000, Ian J Maude wrote:

> I really should have added that the on/off, display, menus etc all
> work. 
> The K2 sees the additional boards etc so it would seem that DC power
> is
> not the problem.
ok, getting there.  I decided as I had already done a reset that I would
start the alignment steps again.  It would seem that the PLL range is in
order but I get nothing except a row of zero's when looking at the VCO
on TP1.  It should be between 8 and 10MHz so I am getting close.  Now
down to those pesky voltages :-)

Ian

-- 
Ian Maude G0VGS Morecambe Lancs UK | ian at gb7mbc.net
Sysop of GB7MBC, the Morecambe Bay Cluster
Running Linux and DXSpider | K2 #4044