[Elecraft] k2 and sb-200

[Stan Rife]

Dwight,
	I am going to use my SB-200 with the Elecraft. I have purchased an
item called a "softkey" from Harbach Electronics. It is a board that mounts
inside the SB-200 and essentially converts the high voltage keying line down
to something the K2 can safely key. I haven't installed it yet...it requires
a little rewiring to get it in the circuit. Trouble is, Harbach is shut down
right now, I think due to a fire or something and Jeff is not taking any
orders until he gets his place back in order.
	There are probably other options, but this is the one I chose
because it designed specifically for, and wires in to, the circuitry of the
SB-200.
 

Stan Rife
W5EWA
Houston, TX
K2 S/N 4216
 

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Dwight
Sent: Tuesday, March 08, 2005 9:17 PM
To: Elecraft at mailman.qth.net
Subject: [Elecraft] k2 and sb-200

So has anyone using the k2/100 to drive a heathkit sb-200 linear? If so can
you give me some pointers on the interface to the amp? Still being new to
the hobby would like some advice on the subject...



__________

Dwight AI4II
__________

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com