[Elecraft] Question on LCD backlight assembly

[W3FPR - Don Wilhelm]

Tim,

If you see no diagonal lines - then remove NOTHING.

Yes there is a film on both sides of the diffuser, and that is a benefit.
If the rear side has the diagonal lines, then that film should be removed
because the stripes show through.

There is no protective film on the back side of the LCD - it is only on the
front side.  You should remove the front film just before putting the front
panel in place - until then, it will protect the LCD surface from scratches
wile you are working on the assembly.

73,
Don W3FPR

> -----Original Message-----
>
> On page 26 of the assembly manual, the 6th step down, it says do
> not remove
> the backing from either side of the diffuser, I assume that means to leave
> the paper backing on that has the writing on it?
>
> Also, I don't thing there is a protective film on the back of the
> LCD, I do
> not see any faint yellow or gray  diagonal lines. Would there be
> any film on
> it without the diagonal lines?
>
> Thanks
> Tim
> NZ8J
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> --
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.323 / Virus Database: 267.8.1/28 - Release Date: 6/24/2005
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.8.1/28 - Release Date: 6/24/2005