[Elecraft] Two Questions

[David Dietrich]

Greetings DE KC9EHQ,
 
I am a little over 1/2 way through my KNB1 before I start on my anniversary present (K1).  
 
My lab is set up in our basement where I have my table in front of a window.  I do have a small oscillating fan blowing air out the window.  Is that enough to keep the solder fumes to a minimum, or do I need a window fan?  I will only be working on this for about 2 hours/session until the radio is completed.  I'd work upstairs at the kitchen table, but the XYL doesn't want this stuff upstairs.  Any suggestions as to what others have done would be helpful.
 
My other question concerns the three capacitors on the bottom of the Rev. C board.  Are they supposed to be mounted so they are lying flat against the board as opposed to the way you would mount them if they were on top?
 
Any help is always great!
 
Thanks & 73,
 
David
KC9EHQ


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com