AW: [Elecraft] KPA100

[Renardy, Martin]

Hallo Brent,

I am member of the "low power group" ;-)), which have had some problems with low power from 
The KPA100 on 20 and 30m. If you are ending in a high current message on 20 not reaching
the 100+Watts, than you maybe can join us. My cure has been to increase C80, C81 in the
PA driver stage. The official value is 5600 pF.

Regards

Martin, DL6KMR


-----Ursprüngliche Nachricht-----
Von: elecraft-bounces at mailman.qth.net [mailto:elecraft-bounces at mailman.qth.net] Im Auftrag von Brent Sutphin WB4X
Gesendet: Samstag, 11. Juni 2005 21:15
An: elecraft at mailman.qth.net
Betreff: [Elecraft] KPA100


I recently built and installed a KPA100 on my K2.  It works great but today 
on twenty meters I got a high current message and the amp shut down.  I have 
the driver current set for 4 amps.  Any suggestions?

Brent   WB4X 


_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com