[Elecraft] KIO2 DB9 Threaded Studs

[Steven Pituch]

Hi all,
I know I am always missing stuff in the manuals, but I have looked and 
not found the answer to this question.

I am installing the KIO2 in my K2 #402 and the two threaded studs that 
connect the female DB9 connector to the chassis at the rear have a 
threaded shaft portion which is 3/16 inch long.  This will clearly 
thread past the top of the hex nuts and run into the side of the circuit 
board.  I am _sure_ (;o)???? yeah!) I installed the board to the db9 
correctly.  I am ready to take a dremel cut off disc to the threaded 
shafts to shorten them.

But this can't be the first time this has happened, so I am thinking I 
goofed somewhere.

How about it?

Thanks,
Steve, W2MY