[Elecraft] Low power on 20m using the KPA100 option

[Vic Rosenthal]

Vic Rosenthal wrote:

> If you are getting 10 watts output when you set the power control to 10 
> watts, check the current draw at this power level by tapping Display. 
> You should be drawing less than 3 amperes in this condition.  Check also 
> at 11 watts, with the KPA100 on.  It shouldn't be much higher. 

I should have said 'with the power control set to 100 watts', not 11 watts.

-- 
73
Vic, K2VCO
Fresno, CA
http://www.qsl.net/k2vco