[Elecraft] K2 VCO Alignment

[Eric Kees]

I’m on page 61 - VCO Alignment where you "adjust Inductor L30 until the 
voltage at R30 reads 6.0 volts"

L30 is at the top stop and the lowest I can get is 6.3 volts. I spread 
the turns on T5 as wide as possible to get this low. T5 has 16 turns. Do 
I need to remove a turn to bring L30 back towards the center and also 
get to 6 volts?

Eric N7HWW


-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.322 / Virus Database: 267.5.0 - Release Date: 2005-06-02