[Elecraft] Testing the compressor on K2 #4913

[John, KI6WX]

Ken;
The compressor uses a power detector to measure the power level and it then 
uses that to set the audio gain.  This results in no distortion of the audio 
signal.  It is possible to run digital modes such as PSK31 through the 
compressor without adding any significant distortion to them.

It is also possible to increase the compression level up to 16:1 by changing 
a resistor value.  I'm not sure I would recommend that because every 
background noise in your shack could be transmitted at full output power.
-John
 KI6WX

----- Original Message ----- 
From: "Ken Bessler" <kg0wx at cox.net>


> Is the design of the K2's compressor so that even at
> 4:1, it's not too harsh? I've been using 2:1 for normal
> ops and 4:1 for difficult contacts. My mic is an old CB
> "Cobra" hand mic (600 ohm). I also have a headset mic
> salvaged from a cell phone (2.2k). I don't use that one
> much.
>
> I talked to KB0OMQ (2 miles away) on 40m today
> and had him rate the compressor for quality at 1:1 and
> 4:1. He said there was no difference in quality - just in
> strength. That was on the CB mic.
>
> That had me scratching my head. Surely, 4:1 compression
> would sound terrible so close in? I'm used to my FT-857D
> where at 65 of 100 it sounded good but at 100 it was
> only good for busting pileups. I would get complaints of my
> audio if I forgot to turn it down for a ragchew.
>
> I'm pretty sure my compressor is working - I get much more
> power for a given sound with it set to 4:1.
>
> Is the K2's compressor just THAT clean?