[Elecraft] K2 #4948 snag

[Mike Markowski]

 "RC" KC5WA wrote on 06/01/05 09:50 ET:
> On page 26 right coluum last instruction reads
> "Place two 3/4" (19mm) spacers over the leads
> of each back light  LED as shown in Figure 5-9"
> -------------------------------------------------
> Now to the best of my knowledge NO SPACERS
> such as those described fig 5-9 were in the parts list.
> Unless it is the two 8mm x 8mm square black pads.
> and these need two be split in half and stacked to get
> the required 1/8 spacing on the diffuser. Thanks for
> any help...

RC,

The spacers are the little pieces you previously will have snapped off
of the switch spacing tool.

73,
Mike  AB3AP