[Elecraft] VCO Alignment

[Vic Rosenthal]

Gary Scott wrote:

>   Im building K2 4988,and on Alignment and test part 2 / VCO
> alignment, I could not get L30 adjusted to 6 volts on R30, Started
> rechecking my work as per directions,everything was fine,so directed
> my attention to T5,adjusted the spreadings of T5 and was able to get 6
> volts at R30,My question is should I rewind T5 ,or just leave T5 alone
> and move on?

If you can get 6 volts at 4 MHz and if all the other band edges are 
within range as specified in the manual, then you do not need to rewind 
anything, you are all set!

-- 
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco