[Elecraft] AGC Threshold voltage?

[Evert Bakker (PA2KW)]

Hello Tim,

I had the same experience. Mine was max 3.78V but it seems nothing to worry
about. I do agree that the given figures and the real ones don't give the
right feeling. I was worried as well. It would haven been "better" to have
the real figures somewhere midway the lower and maximum limits to give a
proper feeling of being normal.

Evert, PA2KW
K2 #4836

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of NZ8J
Sent: 25 July 2005 18:58
To: elecraft at mailman.qth.net
Subject: [Elecraft] AGC Threshold voltage?

The overall receiver gain  of the K2 I just built (serial number 4993) seems
low as compared with my older serial number 315 K2.

The max AGC threshold voltage I can get is 3.82 volts. (3.8 is what is
called for in alignment and Test Part I), but the troubleshooting section
says you can increase the voltage to increase the overall no-signal IF gain
and that a typical setting might be 3.9 volts.  Mine is maxed out at 3.8...
does this sound correct?

Thanks
Tim
Nz8J


_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com