[Elecraft] Weak reception after Phase II

[W3FPR - Don Wilhelm]

Roland,

At this point of construction you should have a fully complete 40 meter
receiver, and it should have good strong signals.

Did you do the AGC Threshold adjustment? you should have, but do recheck it,
and then set CAL S-LO and CAL S-Hi again (with no antenna connected).  If
your problem continues, you can do some signal tracing - try Tom Hammond's
'Quick and Dirty Signal Tracing' and if that does not reveal anything
informative, do the Receive Signal Tracing as outlined in the
Troubleshooting appendix.  If you do not have a signal generator, you can
build up the crystal oscillator shown in the appendix.

73,
Don W3FPR

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Roland
> Sent: Saturday, July 23, 2005 1:24 PM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] Weak reception after Phase II
>
>
> I just completed the phase II alignment on the k2.  I noticed
> that the reception is really weak.  When I find a signal, I have
> to turn the volume all the way up to hear it in my head phones.
> Just wondering if this is normal at this stage before I press on
> to phase III.
> Roland in Stockton, Ca
> kit#3090
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> --
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.338 / Virus Database: 267.9.4/57 - Release Date: 7/22/2005
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.9.4/57 - Release Date: 7/22/2005