[Elecraft] KX1 Antenna Wire - Portable antenna wire comment

[Mike Morrow]

Sandy wrote:


>Is this stuff real flexible?  I've been using some old "MIL SPEC" type #26
guage
>hookup wire!


Scott wrote:


> I am looking for a vendor for the "#26 AWG Teflon coated, silver plated
wire
> that is often recommended on this list for portable KX1 antennas

What is the advantage of this extremely thin wire for antenna use?  No
matter what it's made of, 26 AWG wire is pretty fragile stuff, especially
for the frequent "put up then take down" cyclic use that is typical of
portable antennas.

I'd suggest the use of 14 AWG (!) Flexweave wire.  I know 14 AWG seems
gigantic compared to 26 AWG, but if you've never used Flexweave you can't
know how *extremely* flexible and durable this stuff is.   The 14 AWG
version consists of 168 individual copper strands.   I've played around with
portable wire antennas for decades and when I finally found Flexweave I knew
I'd found perfection.  I've never had to repair any antenna I ever made from
it, even after years of cyclic use.  It coils up tightly for storage,
resists kinking and fraying, and even 100 feet of it is lightweight and
compact.  My 66-foot 40m to 10m dipole takes up very little room in a pack.

One vendor is http://www.thewireman.com/wire.html , item 542 or 544.

There's a natural tendency to want super small antenna components to go with
our similarly compact QRP rigs.  IMHO, that is a grand mistake.   I've
*never* come across even one portable-use situation where the use of stuff
like RG-174 coax or 26 AWG wire was appropriate compared, say,  to RG-58 and
Flexweave.

73,
Mike / KK5F