AW: [Elecraft] K2/100 Assembly

[Renardy, Martin]

Dear Frank,

As far as I remember you will build and test the K2 first without options. If everything is ok, you will install for example the KSB2. During that installation you will have to remove solder bridges and a capacitor, but this is described in the manual of the KSB2.

Regards

Martin

-----Ursprüngliche Nachricht-----
Von: elecraft-bounces at mailman.qth.net [mailto:elecraft-bounces at mailman.qth.net] Im Auftrag von Frank Mayer
Gesendet: Wednesday, July 13, 2005 2:11 PM
An: elecraft at mailman.qth.net
Betreff: [Elecraft] K2/100 Assembly


I am going to order a K2 with a number of the options.  I have also downloaded and read the assembly manual for the K2 as well as the KSB2 board for example.  The assembly and installation instructions for the KSB2 instruct you to disassemble part of the rig for the installation of the board.  Is there any coordination instruction given for building the rig when you are installing the options at the time of rig assembly? Frank  WY3D _______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com