[Elecraft] KX1 need help on last step

[Jean-François Ménard]

Le 05-01-20, à 20:37, Jean-François Ménard a écrit :

> Again,
>
> Using my Elecraft dummy load with my MM set on DC on DL terminal, and 
> also using the formula that come with the Elecraft DL
>
> I have 2.56W on 20M and 3.38W on 40M.... is it normal... !?!?!?
>
> Probably no !?!?, I redo all my toroids perfectly this time !!
>
>
> Le 05-01-20, à 19:52, john_k7fd at charter.net a écrit :
>
>> I think only one bar shows on keydown unless you have the ATU 
>> installed...
>>
>> Are you using an external wattmeter and it shows nothing?
>>
>> John K7FD
>>
>>>
>>> From: Jean-François Ménard <jfmenard at mac.com>
>>> Date: 2005/01/21 Fri AM 12:17:37 GMT
>>> To: Elecraft - Maling List <elecraft at mailman.qth.net>
>>> Subject: [Elecraft] KX1 need help on last step
>>>
>>> I'm running the final step... the transmit test....
>>>
>>> I put my Elecraft 50 Omhs DL... on TX... no output.
>>>
>>> I checked all the DC voltage on RX and TX...
>>>
>>> On RX I noted,
>>>
>>> D3 anode only 3.6 VDC instead of 9.0 VDC
>>> Q2 d=1.08 VDC instead of 4.45 VDC
>>> Q3 d=1.08 VDC instead of 4.45 VDC
>>>
>>> Any idea !?!?!?
>>>
>>> ===========================
>>> Jean-François Ménard / VA2VYZ
>>> Elecraft K2 #4130 / KX1 #999
>>>
>>> http://homepage.mac.com/jfmenard
>>> ===========================
>>> _______________________________________________
>>> Elecraft mailing list
>>> Post to: Elecraft at mailman.qth.net
>>> You must be a subscriber to post to the list.
>>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>>  http://mailman.qth.net/mailman/listinfo/elecraft
>>>
>>> Help: http://mailman.qth.net/subscribers.htm
>>> Elecraft web page: http://www.elecraft.com
>>>
>>
>>
> ===========================
> Jean-François Ménard / VA2VYZ
> Elecraft K2 #4130 / KX1 #999
>
> http://homepage.mac.com/jfmenard
> ===========================
>
>
===========================
Jean-François Ménard / VA2VYZ
Elecraft K2 #4130 / KX1 #999

http://homepage.mac.com/jfmenard
===========================