[Elecraft] frequently low batt

[W3FPR - Don Wilhelm]

I expect there is really nothing wrong.
It is most likely that you bumped the 'display voltage' slide switch on the 
top of the Control Board during the firmware install.  Check and move it 
back to the INT position.  I believe it will 'cure' the problem.
Newer K2s (3000+) have a jumper instead of the switch because of this 
situation.

73,
Don W3FPR

----- Original Message ----- 

> Since I installed the latest software on KSB2 I realize frequently " low
> batt" message at the diplay of my K2.
>
> Anyone got the same problem or have an idea?
>
> Ser.Nr. 1020,
>
>
>
> Greetings out of the snowy cold northern Bavaria.
>
>
>
> 73 de DG9NCL
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>