[Elecraft] K2 IF Amp Alignment and AGC Threshold

[W3FPR - Don Wilhelm]

Chuck,

The AGC Threshold setting of 3.8 volts is the normal recommended starting 
value.  If you are measuring 3.78 volts, thatt is likely OK, but just as a 
quick sanity check, do check the output of the 8 volt regulator U4 on the 
control board.  If it is less than 8 volts, that may be the reason you 
cannot get the AGC Threshold up to the 3.8 volt level - check the soldering 
on the 8A line (refer to the schematic to see the points connected).

In any case, you can modify the AGC Threshold after you have the K2 up and 
running to achieve maximum receiver sensitivity - simply switch between AGC 
on and AGC off on a quiet band - the AGC Threshold should be set so there is 
no reduction in receiver gain with AGC on.  I usually find that the final 
AGC Threshold voltage is somewhere between 3.6 and 3.8 volts.

You have received several other responses about the IF alignment question - 
I can add nothing more.

In answer to your 3rd question about the S-Meter calibration - Yes, one can 
use the Elecraft XG1 (or any other 50 uV signal) to set the S-Meter at S-9. 
The easy way to do that is just what is mentioned in the manual - change S 
HI so the S-meter reads the way you want it to, but if you also insist on 
full S-meter deflection with a VERY strong signal, things get a bit more 
complex.  The settings of S-Lo, S-Hi, and the AGC Threshold all interact and 
can be set to provide whatever S-meter action is pleasing to you - so if you 
are adventure minded, I encourage you to experiment with it until you have 
the settings you desire - If you are not so adventuresome and just 'want it 
to work', do what the manual tells you to do - that will result in a 
perfectly adequate S-meter response.

73,
Don W3FPR

----- Original Message ----- 

>I have a couple of questions about readings I have collected during my 
>present build process.
>
> First:  The procedure outlined for setting the AGC Threshold on page 47 
> recommends setting the voltage from U2 pin 5 to 3.8 volts by adjusting 
> R-1.  In the troubleshooting section Appendix E Page 6, the procedure 
> recommends setting the voltage to 3.9 volts.  As I understand it this is a 
> initial adjustment that I will fine tune later and that I am just 
> adjusting for a peak voltage.  However the maximum I can adjust my U2 Pin 
> 5 voltage is 3.78.  Comments?
>
> Second:  The IF Amplifier Alignment, outlines a procedure to tune the VFO 
> to 7.000 MHz then with the L34 slug turned down 1 1/2 turns from the top 
> of the can, adjust the L34 for signal peak.  I hear a tone at 6,998 MHz 
> and the audible tone is pretty solid for a full one and half turns in 
> either direction on the L34.  I hooked up a DMM to the headphone output 
> and the voltage appears to peak at the top of the L34 can.  Comments?
>
> Third:  I remember seeing a posting that discussed a rather elaborate 
> procedure to Calibrate the K2 S-meter using the Elecraft XG1.  Or was I 
> dreaming?  Can someone point me in the right direction to speed up my 
> search.
>
> 73, KI4DGH
> Chuck G.