[Elecraft] What cable with RASCAL PSK interface

[Mike]

Paul, 

I use a RASCAL with my K2.  I originally bought it to use with a now
dead Kenwood TS930 with an 8-pin mike connector, which is the same as
the K2.

When I built my K2, I set-up the jumpers on the front panel board to use
with my Kenwood mikes.  The RASCAL works great in this configuration.
This interface uses only the Audio, PTT and Ground Lines on the mike
plug.  

The cable you will need depends on how you configure the K2 mike
connector.   Any RASCAL model that has the 8-pin round mike connector
and 3.5 mm speaker plug should have all you need.  You will have to
match the connections on the cable to your K2 mike configuration.    

If you have any additional questions, post a message here with how you
have, or intend to configure the mike input on your K2, and I or
somebody else should be able to help.

73, Mike

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of designer
Sent: Friday, February 18, 2005 1:11 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] what cable with RASCAL PSK interface

If you are using the K2 with the RASCAL interface for PSK, which 
cable did you order with the RASCAL. Thanks.
73,
Paul
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com