[Elecraft] Re: KPA100 middle screw alteration

[Geoffrey Mackenzie-Kennedy]

Don't want to drag this out, but I am with you Ron. I find that the "warts"
give the K2/100 an "unfinished" look, stands out like a sore thumb against
most other gear in the shack. I hope that any new products that might come
from Elecraft will NOT have "warts".

73,
Geoff     GM4ESD

----- Original Message -----
From: "ZL1TW" <ron_w at clear.net.nz>
To: <elecraft at mailman.qth.net>
Sent: Monday, February 07, 2005 3:36 AM
Subject: [Elecraft] Re: KPA100 middle screw alteration


>
>     When I replaced the screws on my K2/100, I drilled a hole right
through
> the heat-sink rail on the KPA100 at the middle screw mounting, and tapped
> it for 4-40 and installed a bit longer screws.
> No messing about with inserts, quick and easy, and is not noticeable. Just
> need the appropriate tap.
> Cheers......Ron ZL1TW
>