[Elecraft] SSB board install - RF board OK - thanks!!!

[David]

yea that ssb board is really tight and a things that you might think
touching won't cause a problem do.
after checking every solder joint with a magnifying glass I start checking
clearances of all the parts and made sure a piece of heavy paper could go
between every thing than reinstalled the ssb and everything worked for me.

----- Original Message ----- 
From: <nz7c at cox.net>
To: <elecraft at mailman.qth.net>
Sent: Saturday, February 05, 2005 9:46 PM
Subject: [Elecraft] SSB board install - RF board OK - thanks!!!


> Thanks folks -
> I love this reflector!!  Thanks to Don, David, Gary,  and many others who
quickly told me how to jumper the RF board - which I did. The K2 still works
perfectly in cw mode  - to my immense pleasure and relief. That just leaves
the SSB board to trouble shoot - a far less daunting task than the RF board.
Thanks very much folks - now to start inspecting that SSB board!
> 73/Tim NZ7C
>
>
> > Hello all -
> > My basic K2 #4667 was operating on cw EXTREMELY well (audio
> > outstanding by the way compared to two prior K2's).
> >
> > However, today I finished and installed the SSB board. W2-W3and C167
> > were removed from the RF board per instructions. According to the menu
> > the SSB board is communicating with the K2. However I literally hear
> > nothing but very quiet unchanging background noise. Before WWV was
> > knocking my ears off at 10 o'clock on the AF knob.  If I remove the
> > antenna there is no change in sound. If I remove the SSB board the
> > background sound comes up but I still don't  to hear anything
> > including WWV.
> >
> > What SHOULD I be able to hear in cw mode with W2-3 cut and C167
> > removed and the SSB board off? I first need to determine if I may have
> > harmed the RF board when removing the 3 items, but I do not not what
> > it should be capable of with C167 removed. If it should be pretty much
> > just like it was prior to cutting the jumpers and C167 then I have a
> > major problem. (Shoot - that baby was running dyno-mite on cw!!!!!)
> >
> > If I can confirm the RF board is still OK then I will put SSB board
> > back in and start voltage checks. Thanks in advance for any help.
> > 73/Tim NZ7C
> > _______________________________________________
> > Elecraft mailing list
> > Post to: Elecraft at mailman.qth.net
> > You must be a subscriber to post to the list.
> > Subscriber Info (Addr. Change, sub, unsub etc.):
> > http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/subscribers.htm
> > Elecraft web page: http://www.elecraft.com
> >
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com