[Elecraft] Attaching sides to K2 RF board

[Kevin Shaw]

Hi Jeff,

I'm about 10 pages ahead of you in building my K2.

Sounds like you have the 2-D fasteners in the wrong spot(s). If you have the
side (left or right) laying on the table with the inside surface facing up
and the two "bare" areas toward you, the 2-D fasteners attach to the holes
at the top left (or right) corner and the right (or left) side.

I hope this makes sense. If not, let me know and I'll send you a picture.

Kevin
N8IQ\4


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of jrb
Sent: Thursday, December 15, 2005 8:08 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Attaching sides to K2 RF board

Hello All and Merry Xmas

Can't figure out where I went wrong here. Attached two 2-D fasteners  
to one bare area and one
"unbare" area as per locations pictured  on page 38. Yet when I went  
to attach the sides to the RF
board, the only holes that fit are the "bare" ones, one of which I've  
attached a 2-D fastener to.

Have I confused left with right sides and attached the fasteners to  
one of the bare areas in error?
i.e. do the formerly masked areas go on the bottom, not the top?

Sorry to be so dense, but the manual is really unclear here, unless  
the stippled areas in the figures are the
bare areas.

TIA

Jeff

KG6ZVT
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com