[Elecraft] SSB audio problem

[Don Wilhelm]

Bob,

In addition, you will need to do a re-alignment of the filters/BFOs after
you change the crystals, and while you are doing that, it is only a few
steps to do a complete calibration.  For the full information on how to
accomplish that, take a look at my website http://w3fpr.qrpradio.com article
on K2 dial calibration - Step 3 of that article goes into the CAL PLL
procedures with references and links provided.

The procedure is not difficult, but does require some care in executing it
to assure good results and optimum performance from your K2.

You will be pleased with the crystal change - not only on SSB, but for CW as
well.

73,
Don W3FPR

> -----Original Message-----

>
> I've ordered the 2nd stage mod kit.  I'm also going to do the matched
> crystal mod on general principles.  Thanks for the help, I may buy a
> microphone for it some day.  I added the SSB for digital modes a few
> years ago but never checked SSB audio.
>
> Bob Baxter AA7EQ
> Walnut Ridge, Ar.
>
> On 12/10/05, Ron D'Eau Claire <rondec at easystreet.com> wrote:
>
> > It's just one mod, Bob. Look up the Elecraft web site "Builders
> Resources".
> > Under "Mods:" you'll find, "K2 2nd Stage Xfil Mod, for
> 'Flatter' SSB Filter
> > Response".
>