[Elecraft] UnPCBs (Rework Eliminators) question

[Bruce Beford]

Received my set of UnPCBs earlier this week, and just wanted to say 
the quality is as good as I have seen in any board. I have a fully-
loaded QRP K2 (s/n 4444). I bought these to have on-hand, in case I 
ever need/want to remove an option module, and keep the radio 
operational. These will fit the bill nicely, with a quality product 
that will be right at home in my beloved K2.

Now the question. At some point I will probably want to build 
another K2, and start with the base model, gradually adding options. 
Has a list of parts been made indicating the number/size of female 
headers and other components needed to put all the unmodules in a 
base K2? I remember seeing an exchange on the Elecraft email 
reflector about his, but am unsure if a final tally or list was ever 
posted.

I seem to remember mention of 8 or 9 female headers. (I could, of 
course simply count the number on the un-modules...) I am most 
interested in the other discrete components that are added or 
replaced as the options are added. I do remember that a resistor for 
the KNB2 was needed. What else? A complete list of any 
resistors/caps etc would be handy.

Thanks in advance, and thanks again for a great product!

73,
Bruce, N1RX