[Elecraft] Power Supply (WAS: New amp)

Stan Rife srife at swbell.net
Thu Aug 18 18:57:24 EDT 2005


	That's what I have done here. I have a 20 amp VJ Products and a
RS-35 Astron. I have them in parallel and fed in to a home brewed
distribution box. I had often wondered if the difference in current rating
would create any problem. Also, I have never checked to see if they both
have exactly the same output voltage. Would either of the above present any
problems?
  

Stan Rife
W5EWA
Houston, TX
K2 S/N 4216
 

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Ron D'Eau Claire
Sent: Thursday, August 18, 2005 12:51 PM
To: 'David'; elecraft at mailman.qth.net
Subject: [Elecraft] Power Supply (WAS: New amp)

David wrote:
Thanks everyone I have the answers I need and I am now planning to purchase
an rs50m for my shack

-----------------------

A few things to consider:

1) A 20 amp power supply will run the K2/100 with current to spare. My
K2/100 runs 16 to 18 amps from my Astron 20M.

2) Large supplies (even the 20 am, but especially one like a 50 amp) can be
very dangerous! While you won't get a shock from 13 vdc, they require all
the care you'd exercise working with an automobile battery. Shorts can cause
instant fires. Hot, molten metal spraying, splattering and dribbling all
over the place from a short can burn lots of holes in things, including your
own body and eyes. Shorts tend to become instantly welded in place and if
it's not good enough to cause the crowbar circuit to trip, the power supply
will keep dumping current into the circuit. An RS 50 supply will dump 50
amps into a 0.3 ohm short nonstop. Fuse everything and be careful just the
same. 

3) You might get more amps for your buck by buying two or three smaller
supplies than one big supply, and thereby be less likely to experience a
total failure if a supply dies on you.

Ron AC7AC



_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com



More information about the Elecraft mailing list