[Elecraft] routine question

[W3FPR - Don Wilhelm]

I routinely use cut off component leads on the thermistor board - simply
because they are laying there in the bench.  If you stick them into a black
foam block, you can get 3 or 4 aligned at one time before soldering (it is
just faster that way.

Another hint is to cut the 8 leads at an angle (so one end is full length
and the others are progressively shorter) and it is easier to insert the
leads into the holes.

73,
Don W3FPR

> -----Original Message-----
>
> when it come to RP3 on the main board instead of using the green hookup
> wire, is it ok to use cut leads? they are easier to work with
>
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.10.8/71 - Release Date: 8/12/2005